BG Nexus Moulded 2 Gang 2 Way 10AX Switch is a modern design that will blend with any décor. Suitable for use in domestic or commercial installations.
BG’s Nexus range of plate switches have been designed to perform at 10AX inductive loads.
Features
Stylish modern profile finished in White
Covers to conceal fixing screws for a clean finish
Colour Coded Terminals with backed out captive screws for easy installation
10 Amp, 10AX Inductive Rated
₦3,500.00
CompareBG Nexus Moulded 2 Gang 2 Way 10AX Switch is a modern design that will blend with any décor. Suitable for use in domestic or commercial installations.
BG’s Nexus range of plate switches have been designed to perform at 10AX inductive loads.
Suitable for under and over-ground usage alike, 25mm 4 Core Armoured Cable is a dust and waterproof variant of electrical cable that is commonly found within powered networks and supplying mains electricity to a large variety of devices, both domestic and industrial.
This particular type of cable is constructed using Plain Annealed Stranded Copper for the conductors, XLPE (Cross-Linked Polyethylene) for the insulation, PVC (Polyvinyl Chloride) for the bedding and sheathing and Steel Wire for the armouring.
Not only does the Steel Wire Armour provide a method of mechanical protection, meaning it is suitable for installation into highly-corrosive environments, the armour also provides a form of CPC (Circuit Protective Conductor) meaning it can be used as an earth for the cable. This means that an earth core/cable is not required although it is still recommended as an extra safety measure.
No. of cores / size of cable – 4
Approx overall diameter – 18.7mm
Approx weight (m) – 0.75Kg
Conductors – Plain Annealed Stranded Copper
Insulation – Cross-Linked Polyethylene (XLPE)
Bedding – PVC
Armour / Protection – Steel Wire
Sheath / Jacket – PVC
Colour – Black
Application – Primarily found within powered networks and providing mains electricity to powered devices.
Voltage Rating – 600/1000Vt
Number of optical fibers cores 3 and 4 other numbers available upon request, Options available for PVC, LSZH or PE outer jacket, which is ultra-violet radiation resistant, water-proof, mildew-proof,environmental stress endurable and with no acidic gas released to corrode switch room equipment.
Features
Compact DBs which occupy minimum space
Raised neutral link for easy wiring
Suitable for surface & fush mounting
Detachable din bar with end stoppers for easy assembly of breakers
Supplied with fully shielded bus-bars
Level marks for providing indication for fitment in wall
Supplied with neutral & earth link, top & bottom detachable plates
Supplied with masking sheet to protect components from cement during plastering
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.
There are no reviews yet.