Lattice Copper earth mats are designed as a more economical cost option to the solid earth mats.
Furse Copper Lattice Earth Mat & Plates
Used in areas where driving earth rods might be impractical, unable to attain an effective earth in shallow soil with underlying rocks or where low earth soil conditions are found. Manufactured from Copper tape 3mm thick .
₦6,500.00
CompareBased on 0 reviews
Be the first to review “Furse Copper Lattice Earth Mat & Plates”
-
CHANGEOVER SWITCHES, Electro, GEAR SWITCHES & CHANGEOVER
100Amp Knife Switch
Type A, single-throw and double-throw, non-fusible knife switches have a corrosion resistant finish, are mounted on GPO-3 bases and have high clips and hinges. The high clips and hinges simplify the front-of-board connections. Available 30 Amp thru 2000 Amp.
Fusible Type A knife switches are arranged with fuse holders which will accept standard code fuses. When mounted on a panel the single-throw switch is fusible at the bottom. Available 30 Amp through 600 Amp at 250, 480 or 600 volt.SKU: 781 -
-
ELECTRICAL FITTINGS, Electro, MODULAR FITTING
4x36W 600×600 Recessed Modular Prismatic
Modular Fitting has an extremely small recess depth 53mm which makes it perfect for shallow ceiling voids. It is also suitable for lay in suspended grid ceilings and comes complete with wire retention safety cable. Rapid installation and maintenance are further facilitated by a quick release louvre device, which is particularly useful during potentially disruptive lamp changes. Ivy Classic is also supplied with a peel off protective cover, to keep the luminaire bright, clean and dust free during carriage and installation.
Once in place, Modular Fitting offers bright, glare free lighting courtesy of its brilliant aluminum louvre and either its 4 x 14W or 3 x 14W T5 lamps. This efficient combination of source and reflector offers a high light output ratio (LOR) of up to 78% and more.
SKU: 057 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 18 – 23amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload7 -
CABLE AND CABLE MANAGEMENT, Electro, SINGLE CORE WIRE
NigerChin 2.5mm Single Core Copper Wire – Red
We offer other range of products across various categories and sub categories and our services are Procurement, installation and Management etc of electrical products, should you have any inquiry we are always here to do our best to promptly answer you.
SKU: 354
There are no reviews yet.