In 1927, MEM embarked on a new field of manufacture – motor control gear, to meet the increasing use of electric motors in industry, and in 1965 announced its first miniature circuit breaker range. Delta Metal acquires MEM in 1971 to enter the electrical sector and Delta’s Electrical Division then consolidates several divisions of MEM (250V, 500V), as well as Bill Switchgear, under the “MEM” brand in 1998 The Electrical Division of Delta was acquired by Eaton Corporation in 2003, including the MEM, Bill and Holec brands, to spearhead the drive into global markets with products designed to meet international standards
MEM – Eaton 63A TPN Gear Switch
The top and bottom endplates are removable. Door can be removed for ease of installation. Incorporate knockouts and gasketed doors, IP41 rated protection. Handle: chromium-plated handles with ON (I) / OFF (O) indication. The switch can be locked ON or OFF by means of a padlock. Internal fixing: enables the unit to be mounted side by side with other units. Maximum current: 63A Number of Poles: 3 Poles. 3 Phase. Switches: quick make-and-break type, suitable for use on AC or DOC. Removable moving contact assemblies: to facilitate wiring. Interiors comprise porcelain bases fitted with non-ferrous conducting components.
Based on 0 reviews
- Vendor: admin
- No ratings found yet!
- CHANDELIER LIGHT, Electro, HOME&OFFICE LIGHTING, LIGHTING
5 Arm Light Fitting Marie Therese
‘-For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self- certification scheme. Further information is available online or from your local authority-SKU: 234
- ELECTRICAL FITTINGS, Electro, TRUNCKING
75x75mm Dignity PVC Trunking
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 413
- CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 4-6amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload1