Barricade tape is brightly colored tape (often incorporating a two-tone pattern of alternating yellow-black or red-white stripes or the words “Caution” or “Danger” in prominent lettering) that is used to warn or catch the attention of passersby of an area or situation containing a possible hazard
Caution Line Tape-Safety Warning Tape
. It acts as a minor impediment to prevent accidental entrance to that area or situation and as a result enhances general safety.
₦0.00
CompareBased on 0 reviews
Be the first to review “Caution Line Tape-Safety Warning Tape”
-
ELECTRICAL INDUSTRIAL, TRANSFORMER
ABB Transformer 300KVA 11/400KV
Distribution transformers are typically oil-immersed and suitable for pole-, pad- or ground-mounting. They represent an economical option for certain networks, particularly those with low population densities.
Depending upon requirements, transformers may be connected between two phases of a three-phase system (two high voltage bushings) or from one phase to ground (single high voltage bushing).
The units are suitable for residential overhead distribution loads, as well as light commercial or industrial loads and diversified power applications.
Product scope
- Primary voltage: 300KV
- Typical fluid: mineral oil
SKU: DTS30011 -
ARMOURED CABLE, ELECTRICAL INDUSTRIAL
120mm x 4Core Armoured Cable (Kabelmetal Nexans Nigeria)/Per meter
ARMOURED CABLE, ELECTRICAL INDUSTRIAL120mm x 4Core Armoured Cable (Kabelmetal Nexans Nigeria)/Per meter
120mm 4 Core Armoured Cable is a variant of steel wire armoured cable used for industrial electrical applications as well as being suitable for direct burial to carry mains electricity to various powered devices. It is also commonly found within powered networks such as within power stations and factories, etc.
This cable is commonly identified by the following construction; plain annealed stranded copper for the cores/conductors, polyvinyl chloride for the bedding and sheathing, cross-linked polyethylene for the insulation, with a steel wire armour protecting the layers beneath.
Although this cable is suitable for powering smaller, more domestic installations such as powering an outdoor shed or house as well as garden/water features, it is most commonly found within more industrial practices, as mentioned previously.Voltage Rating: 600/1000Vt
SKU: 1522 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 18 – 23amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload7
There are no reviews yet.