T2 lamp holder with push bar, threaded. 0.5in threaded, T2 lamp holder with push bar switch. If in doubt consult a qualified electrician
Lamp Holder 1/2in Push Bar
Always read instructions.
₦150.00
CompareBased on 0 reviews
Be the first to review “Lamp Holder 1/2in Push Bar”
-
ARMOURED CABLE, ELECTRICAL INDUSTRIAL
120mm x 4Core Armoured Cable (Coleman)/Per meter
120mm 4 Core Armoured Cable is a variant of steel wire armoured cable used for industrial electrical applications as well as being suitable for direct burial to carry mains electricity to various powered devices. It is also commonly found within powered networks such as within power stations and factories, etc.
This cable is commonly identified by the following construction; plain annealed stranded copper for the cores/conductors, polyvinyl chloride for the bedding and sheathing, cross-linked polyethylene for the insulation, with a steel wire armour protecting the layers beneath.
Although this cable is suitable for powering smaller, more domestic installations such as powering an outdoor shed or house as well as garden/water features, it is most commonly found within more industrial practices, as mentioned previously.Voltage Rating: 600/1000Vt
SKU: colmean120mm -
EMERGENCY LIGHTS, FLUORESCENT FITTINGS, FLUORESENT TUBES
BARDIC EMERGENCY LIGHT
BARDIC, a brand of MPower supplies off the shelf product lines for emergency and exit lighting including centrally monitored systems and custom solutions for building owners, maintenance managers and contractors seeking emergency lighting with energy efficient capabilities and a long lasting design life.
SELF CONTAINED EMERGENCY LIGHT
CA8/NM/3F
RATING: 3 HOURS NON-MAINTAINED W/O REST MODE
RATED INPUT: ~230/240Vac + 6% – 10% 50/60hZ 9va
LAMP: 8W T5 6400K
WITH SEAL FITTED = IP65SKU: BARDIC 1 -
ELECTRICAL INDUSTRIAL, Electro, TRANSFORMER
ABB 200KVA 11/400KV Distribution Transformer
Distribution transformers are typically oil-immersed and suitable for pole-, pad- or ground-mounting. They represent an economical option for certain networks, particularly those with low population densities.
Depending upon requirements, transformers may be connected between two phases of a three-phase system (two high voltage bushings) or from one phase to ground (single high voltage bushing).
The units are suitable for residential overhead distribution loads, as well as light commercial or industrial loads and diversified power applications.
Product scope
- Primary voltage: up to 36 kV
- Typical fluid: mineral oil
SKU: transfor200kva
There are no reviews yet.