This is a suspension kit for our LED panels, allowing the LED panels to be suspended from a celing. These are ideal for spaces without a suspended ceiling.
Packaging Info: Comes in 4 pieces complete with fixings
Depth: 55mm
Colour: White
₦10,000.00
CompareThis is a suspension kit for our LED panels, allowing the LED panels to be suspended from a celing. These are ideal for spaces without a suspended ceiling.
Packaging Info: Comes in 4 pieces complete with fixings
Depth: 55mm
Colour: White
Compact fluorescent lamps by OSRAM has high level of economy. They have an impressive average service life up to 20 times longer and consume considerably less energy by up to 80%. Because of their higher efficiency they can be operated very economically and soon make pay for themselves.
Compact fluorescent lamps by OSRAM also reduce CO2 emissions in comparison to similar incandescent lamps by up to 80 % – an active contribution to climate protection combined with incredible cost reduction.
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.
*solar panel: 280W/36V *2
*battery: 12V/100AH *2
*controller: 48V/40A
*inverter: 48V/1500W sine wave
* Multiple AC output: 4* 220V AC.
*Electricity generated per day: Approximately 3.6KWH in
sunny weather. * Electricity consumed per day: Maximum power
consumption 5.6KWH.
*Total power consumption of loads should not exceed
2400W per hour
*AC Adapter :by option.
Distribution transformers are typically oil-immersed and suitable for pole-, pad- or ground-mounting. They represent an economical option for certain networks, particularly those with low population densities.
Depending upon requirements, transformers may be connected between two phases of a three-phase system (two high voltage bushings) or from one phase to ground (single high voltage bushing).
The units are suitable for residential overhead distribution loads, as well as light commercial or industrial loads and diversified power applications.
Product scope
There are no reviews yet.