Ratings: Ampere ratings of Type A, non-fusible, knife switches are based on a temperature rise of not more than 30 degrees C. above an ambient temperature of not more than 40 degrees C. when mounted in open air. Enclosed ratings are based on the switches being mounted in enclosures with adequate ventilation and with bus or cable of appropriate size.
100Amp Knife Switch
Type A, single-throw and double-throw, non-fusible knife switches have a corrosion resistant finish, are mounted on GPO-3 bases and have high clips and hinges. The high clips and hinges simplify the front-of-board connections. Available 30 Amp thru 2000 Amp.
Fusible Type A knife switches are arranged with fuse holders which will accept standard code fuses. When mounted on a panel the single-throw switch is fusible at the bottom. Available 30 Amp through 600 Amp at 250, 480 or 600 volt.
₦6,500.00
CompareBased on 0 reviews
Be the first to review “100Amp Knife Switch”
-
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 1.6 – 2.5amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload3 -
-
ELECTRICAL INDUSTRIAL, Electro, PURE COPPER MATERIALS
Furse Copper Lattice Earth Mat & Plates
Used in areas where driving earth rods might be impractical, unable to attain an effective earth in shallow soil with underlying rocks or where low earth soil conditions are found. Manufactured from Copper tape 3mm thick .
SKU: 292 -
CEILING LIGHTS, Electro, HOME&OFFICE LIGHTING, LIGHTING
Flush Fitting Ceiling Light Chrome Effect
This flush-fitted domed chrome frosted ceiling light takes either a GLS ES 42W halogen bulb, or a 12W energy saver, which are not included. Flush fitting ceiling light fitting. Wiring required. Maximum 1x 42W E27 GLS Halogen ES bulb or 12W energy saving bulb required. Bulb not included. Suitable for use in bathrooms excluding zone 0,1,2. For indoor use only. Always read instructions.
SKU: 1391
There are no reviews yet.