BG Moulded 1 Gang 1 Way Switch is a modern design that will blend with any décor. Suitable for use in domestic or commercial installations.
BG’s Nexus range of plate switches have been designed to perform at 10AX inductive loads.
Features
Stylish modern profile finished in White
Covers to conceal fixing screws for a clean finish
Colour Coded Terminals with backed out captive screws for easy installation
₦2,700.00
CompareBG Moulded 1 Gang 1 Way Switch is a modern design that will blend with any décor. Suitable for use in domestic or commercial installations.
BG’s Nexus range of plate switches have been designed to perform at 10AX inductive loads.
Stanley Products always provides new technology for all industrial requirements, with excellent value for their investments. You can depend upon for matchless quality on all Stanley Products. Our new range products in sheet metal Side Handle Operating Switchgear are made as per industrial requirements with powder coating. This certificate of “Stanley” original products, issued with the assurance as the same has been manufactured in accordance with requirement of IEC-60947-3 (2005-06). Quality system, standards and mechanism has been tested satisfactory to the specific test as follows: 1. Dielectric Test 2. Mechanical Operation Test 3. High Voltage Test 4. Insulation Resistance Test 5. Temperature Rise Test 6. Mini Volt Drop Test STANLEY 400A Gear Switch
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.
Type A, single-throw and double-throw, non-fusible knife switches have a corrosion resistant finish, are mounted on GPO-3 bases and have high clips and hinges. The high clips and hinges simplify the front-of-board connections. Available 30 Amp thru 2000 Amp.
Fusible Type A knife switches are arranged with fuse holders which will accept standard code fuses. When mounted on a panel the single-throw switch is fusible at the bottom. Available 30 Amp through 600 Amp at 250, 480 or 600 volt.
‘-For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or from your local authority-
There are no reviews yet.