Based on 0 reviews
Be the first to review “C Torch LED 12watt”
-
ELECTRICAL FITTINGS, Electro, TRUNCKING
16x25mm Dignity PVC Trunking
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 408 -
SOLAR POWERED
Solar Power Systems 100W/18V
*solar panel: 100W/18V
*battery: 12V/100AH
*controller: 12V/15A
*inverter: 12V/300W sine wave * Multiple AC and DC output interface to achieve multiple
purposes: 1*20V DC, 1*12V DC, 1* 9V DC, 1*3.3V DC,
4*5V USB, 2* 220V AC.
*Electricity generated per day: Approximately 0.3KWH in
sunny weather. * Electricity consumed per day: Maximum power
consumption 0.95 KWH.
*Total power consumption of loads should not exceed
200W per hour *AC
Adapter : Input AC100-240V,output DC16V/3-4A, by
option.SKU: 1554 -
DISTRIBUTION BOARDS, DISTRIBUTION BOARDS, Electro
Eaton-MEM 6way Three Phase(TPN) Distribution Board C/W MCB
DISTRIBUTION BOARDS, DISTRIBUTION BOARDS, ElectroEaton-MEM 6way Three Phase(TPN) Distribution Board C/W MCB
Features Compact DBs which occupy minimum space Raised neutral link for easy wiring Suitable for surface & fush mounting Detachable din bar with end stoppers for easy assembly of breakers Supplied with fully shielded bus-bars Level marks for providing indication for fitment in wall Supplied with neutral & earth link, top & bottom detachable plates Supplied with masking sheet to protect components from cement during plastering
SKU: 263 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 2.3-4amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload2
There are no reviews yet.