Metallic Delta Cable trays are manufactured for the smooth and easy pulling of cable from one point to another to BS EN 61537:2002. We have designed the best cable trays, by taking care of cable loads and practical site problems. Wherever possible all fitting are made of state of art single piece construction. Slotting Patterns are in such a way that it enables the easy cutting and joining at any point without drilling at site. Design allows greater cable filling capacity and smooth turning at bends.
Delta Cable Tray 500 X 50 X 3mtrs Hot Dip Galvanized
₦38,580.00
CompareBased on 0 reviews
Be the first to review “Delta Cable Tray 500 X 50 X 3mtrs Hot Dip Galvanized”
-
ELECTRICAL FITTINGS, Electro, TRUNCKING
75x75mm Dignity PVC Trunking
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 413 -
ACCESSORIES, COMPUTING, PRINTERS
CANONSCAN LIDE 220
For certain products, a driver is necessary to enable the connection between your product and a computer. On this tab, you will find the applicable drivers for your product or in the absence of any drivers, an explanation of your product’s compatibility with each operating system.
SKU: Canon220 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 30 – 40amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload5 -
DISTRIBUTION BOARDS, DISTRIBUTION BOARDS, Electro
Eaton-MEM 12way Three Phase(TPN) Distribution Board C/W MCB
DISTRIBUTION BOARDS, DISTRIBUTION BOARDS, ElectroEaton-MEM 12way Three Phase(TPN) Distribution Board C/W MCB
Features Compact DBs which occupy minimum space Raised neutral link for easy wiring Suitable for surface & fush mounting Detachable din bar with end stoppers for easy assembly of breakers Supplied with fully shielded bus-bars Level marks for providing indication for fitment in wall Supplied with neutral & earth link, top & bottom detachable plates Supplied with masking sheet to protect components from cement during plastering
SKU: 262
There are no reviews yet.