GoodmanTM switches and sockets are the perfect stepping stone to success. Suitable for matching down-lamps and colorful lamps, our GoodmanTM switches and sockets are not only ideal for electrical fittings but they also add to the aesthetics of the room.
Based on 0 reviews
Be the first to review “Goodman 3 Gang 2 Way Switch-White Off/On”
-
Electro, SOCKETS & SWITCHES, SWITCHES
MK 2-GANG 2-WAY 10AX LIGHT SWITCH WHITE
Brand – MK
Colour – White
No. of Gangs – 2
No. of Ways – 2
Pack Size – 1
Parent Colour – White
Pieces in Pack/Case – 1
Product Type – Light Switch
Profile Type – Slim
Switches & Sockets Finish – Plastic
Switches & Sockets Product Type – Light Switch
Switches & Sockets Profile Type – Raised Slim
Total Product Weight – 0.075 kgSKU: 1482 -
Electro, SOCKETS & SWITCHES, SWITCHES
Single 400W Dimmer Chrome
Single gang dimmer switch in chrome the ultimate in contemporary switches. This product must be installed in accordance with local Building Regulations. If in any doubt, or where required by the law, consult a competent person who is registered with an electrical self certification scheme.
SKU: 853 -
ELECTRICAL FITTINGS, Electro, TRUNCKING
16x25mm Dignity PVC Trunking
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 408 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 4-6amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload1
There are no reviews yet.