TeSys LR9D and LR9F electronic overload relays provide simple, flexible and reliable motor protection.
TeSys Schneider Electric Overload Relays 7 – 10amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.
₦11,500.00
CompareBased on 0 reviews
Be the first to review “TeSys Schneider Electric Overload Relays 7 – 10amps”
-
ELECTRICAL FITTINGS, Electro, TRUNCKING
25x40mm Dignity PVC Trunking
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 409 -
ELECTRICAL INDUSTRIAL, Electro, WIRE CABLE TRAY & CABLE LADDER
200mm x 50mm Foreign Wire Merge Cable Tray By 3Meter
ELECTRICAL INDUSTRIAL, Electro, WIRE CABLE TRAY & CABLE LADDER200mm x 50mm Foreign Wire Merge Cable Tray By 3Meter
Cable tray are the most common solution for supporting and routing of cables in an installation.
For this reason, cable tray are available in a variety of sizes and standards, in order to cover the
wide range of applications.Embedded perforations for :
– extra load capacity
– better aeration
– better stability
– better condensation drainage
-50x300mmAlternative perforations for :
– better fixation on the supports
– very useful for cable fixation
-Standard finish GalvanizedSKU: 295 -
ELECTRICAL INDUSTRIAL, Electro, TRANSFORMER
ABB 1.5KVA 11/400KV Distribution Transformer
Distribution transformers are typically oil-immersed and suitable for pole-, pad- or ground-mounting. They represent an economical option for certain networks, particularly those with low population densities.
Depending upon requirements, transformers may be connected between two phases of a three-phase system (two high voltage bushings) or from one phase to ground (single high voltage bushing).
The units are suitable for residential overhead distribution loads, as well as light commercial or industrial loads and diversified power applications.
Product scope
- Primary voltage: up to 36 kV
- Typical fluid: mineral oil
SKU: transfor1.5kva
There are no reviews yet.