Die-casting aluminum Panel light slim round
Material:Aluminum Alloy
CRI:≥80
Voltage:AC85-265V 50/60Hz
CE Standard
FOR CEILING,RECESSED TYPE,SUITABLE FOR HOME AND OFFICE USE,FLAT AND SEAMLESS DESIGN,COMPLETE WITH TRANSFORMER
Die-casting aluminum Panel light slim round
Material:Aluminum Alloy
CRI:≥80
Voltage:AC85-265V 50/60Hz
CE Standard
FOR CEILING,RECESSED TYPE,SUITABLE FOR HOME AND OFFICE USE,FLAT AND SEAMLESS DESIGN,COMPLETE WITH TRANSFORMER
Cable tray are the most common solution for supporting and routing of cables in an installation.
For this reason, cable tray are available in a variety of sizes and standards, in order to cover the
wide range of applications.
Embedded perforations for :
– extra load capacity
– better aeration
– better stability
– better condensation drainage
-50x300mm
Alternative perforations for :
– better fixation on the supports
– very useful for cable fixation
-Standard finish Galvanized
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.
Change Over Switch | Knife Switch
Reliable isolation and contact position indication
Tested as switch – disconnector according to IEC
Style: Double throw knife switch
Material: 100% Marble
Poles: 2P ,3P ,4P
Voltage:110V-600V
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.
There are no reviews yet.