Single Phase (SPN) 4, 6, 8 & 12Ways, MCB Protected Socket: Single Pole SPN, 10Amp, 15Amp, 20Amp, 32Amp, 40Amp, 50Amp, 63Amp, 80Amp, 100Amp.
12way Single Phase Eaton-MEM Consumer Unit Distribution Board C/W MCB
These are most elegantly designed DBs, to suit the decor of homes Raised neutral link for easy wiring Spring loaded outer cover swings open by just pressing the lock as in case of Elegance series. Supplied with masking sheet to protect components from cement during plastering Supplied with neutral & earth link, top & bottom detachable plates.
₦188,000.00
CompareBased on 0 reviews
Be the first to review “12way Single Phase Eaton-MEM Consumer Unit Distribution Board C/W MCB”
-
CIRCUIT BREAKERS, DISTRIBUTION BOARDS, Electro
ABB SACE Tmax XT1B 160 Breaker 20A
A complete range of moulded case circuit-breakers up to 3200 A.
All the circuit-breakers, both three-pole and four-pole, are available in the fixed version; sizes T4 and T5 in the plug-in version and T4, T5, T6, and T7 also in the withdrawable one.
* High breaking capacity in compact dimensions
High values of short circuit breaking capacity are guaranteed at different voltage levels, without compromising overall dimensions.* Flexibility of use
Thermomagnetic and electronic trip units are available for use in AC/DC or in AC only. It is possible to interchange trip units keeping the
same breaking part, so that installation can be upgraded with fewer costs.* Advanced protection
A complete range of electronic trip units is suitable for different level of protection, even enhancing selectivity values with Early Fault
Detection and Prevention algorithm.SKU: ABB TXB2 -
ACCESSORIES
Photocell Waterproof AC Auto Sensor
How often do you forget to switch off outside security lights? Sometimes because there was power outage when leaving home only to return and be told that there has been power (light) since you left home with your outside lights (bulbs) draining your power-recharge.
SKU: photocell1 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 18 – 23amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload7 -
Electro, HOME&OFFICE LIGHTING, LIGHTING, SPOTLIGHTS
3 Arm Dome Spotlight Ceiling Light Silver
‘-For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self- certification scheme. Further information is available online or from your local authority-
SKU: 223
There are no reviews yet.