Barricade tape is brightly colored tape (often incorporating a two-tone pattern of alternating yellow-black or red-white stripes or the words “Caution” or “Danger” in prominent lettering) that is used to warn or catch the attention of passersby of an area or situation containing a possible hazard
Caution Line Tape-Safety Warning Tape
. It acts as a minor impediment to prevent accidental entrance to that area or situation and as a result enhances general safety.
₦0.00
CompareBased on 0 reviews
Be the first to review “Caution Line Tape-Safety Warning Tape”
-
TRUNCKING
40 x 25mm PVC Trunking
* N450.00 (per length)
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 1497 -
Electro, FLUORESENT TUBES, LIGHT BULBS, LIGHTING
Sylvania Fluorescent Tube – 4ft
For more than 100 years, OSRAM SYLVANIA has been a leader in the development of innovative lighting. SYLVANIA provides over 3000 SYLVANIA and OSRAM branded products for a variety of lighting applications, each one designed and manufactured to the highest possible standards. Average life: 10000 hours Diameter: 25mm Base: G13 2 pin Shape: linear Length: 600mm Lamp type: T8 Energy label: A Colour temperature: 4000K Colour appearance: cool daylight Triphosphor tubes for high quality tubes
SKU: 145 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 4-6amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload1
There are no reviews yet.