Barricade tape is brightly colored tape (often incorporating a two-tone pattern of alternating yellow-black or red-white stripes or the words “Caution” or “Danger” in prominent lettering) that is used to warn or catch the attention of passersby of an area or situation containing a possible hazard
Caution Line Tape-Safety Warning Tape
. It acts as a minor impediment to prevent accidental entrance to that area or situation and as a result enhances general safety.
₦0.00
CompareBased on 0 reviews
Be the first to review “Caution Line Tape-Safety Warning Tape”
-
SOLAR POWERED
Solar Power Systems 100W/18V
*solar panel: 100W/18V
*battery: 12V/100AH
*controller: 12V/15A
*inverter: 12V/300W sine wave * Multiple AC and DC output interface to achieve multiple
purposes: 1*20V DC, 1*12V DC, 1* 9V DC, 1*3.3V DC,
4*5V USB, 2* 220V AC.
*Electricity generated per day: Approximately 0.3KWH in
sunny weather. * Electricity consumed per day: Maximum power
consumption 0.95 KWH.
*Total power consumption of loads should not exceed
200W per hour *AC
Adapter : Input AC100-240V,output DC16V/3-4A, by
option.SKU: 1554 -
ACCESSORIES, ELECTRICAL INDUSTRIAL
Industrial Extension, 2.5mm x 40mtr – 3way – Brennenstuhl
FEATURES:
– Ergonomic cable guide handle for perfect cable-management during winding
– With thermal cut-out protection against overheating or overload
– Safety Cut Out.
– Nominal current: 13 A.
– Suited for 40 meters of cable.
– Equipped with 3 sockets with self closing covers.
– Protection against overheating.
– Indicator light to prevent overheating.
– Voltage: 220 – 240V
– Made in GermanySKU: Extension1 -
GEAR SWITCHES
Stanley Switch Gears – Side Handle 32Amp
Stanley Products always provides new technology for all industrial requirements, with excellent value for their investments. You can depend upon for matchless quality on all Stanley Products. Our new range products in sheet metal Side Handle Operating Switchgear are made as per industrial requirements with powder coating. This certificate of “Stanley” original products, issued with the assurance as the same has been manufactured in accordance with requirement of IEC-60947-3 (2005-06). Quality system, standards and mechanism has been tested satisfactory to the specific test as follows: 1. Dielectric Test 2. Mechanical Operation Test 3. High Voltage Test 4. Insulation Resistance Test 5. Temperature Rise Test 6. Mini Volt Drop Test STANLEY 32A Gear Switch
SKU: StanleyGear3 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 7 – 10amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload4
There are no reviews yet.