This GE Energy Saving Bulb offers up to an 80percent saving on energy and lasts up to six years (approximately 6,000 hours). 7 Watts equivalent to a 31W standard bulb. Energy Rating A. 310 Lumen. E27 Edison Screw Fitting Non Dimmable. Energy saving bulb, A rating. Lasts up to 6 years. Equivalent to 31W standard bulb. Starting time < 60sec. Not dimmer compatible. Contains 2mg Hg.
General Electric GE Energy Saving Light Bulb E27 ES 7W/310lu
See pack for further details.
₦0.00
CompareBased on 0 reviews
Be the first to review “General Electric GE Energy Saving Light Bulb E27 ES 7W/310lu”
-
-
TRUNCKING
40 x 25mm PVC Trunking
* N450.00 (per length)
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 1497 -
HIGH BAY LIGHTS
Luceco LED Highbay Light LHBR 200W (31200lm)
Product Features
IP65 highbay with industry-leading efficacy
Multiple mounting options
Integrated heat sink
IP65 PIR sensor compatible
IP65 Integrated emergency
Stainless steel hardware
0-10V Dimmable
Supplied with 2′ of SJTW cable
1′ safety chain includedColor Temperature: 4000K, 5000K
Efficacy: Up to 160lm/W
Lumen Maintenance: L70 calculated at 100,000hrs
IP Rating: IP65
Beam Angle: 60°, 90°, 120°SKU: Luceco200w -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 7 – 10amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload4
There are no reviews yet.