100 Amp Ceramic Fuse and Base New brand with high quality Product Description Mainly used for protecting the electrical circuit against overload and short-circuits. Protection against overload and short circuit in electric lines.
STANLEY 100Amp Fuse And Base
Always read the instructions
₦38,500.00
CompareBased on 0 reviews
Be the first to review “STANLEY 100Amp Fuse And Base”
-
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 7 – 10amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload4 -
FLUORESCENT FITTINGS
Philip Fluorescent Choke – Philips
Electro-magnetic Ballasts for TL-D Fluorescent Lamps
– Equipped with screw contacts
– Reliable electrical and mechanical performance
– Optimum lamp performance under optimum temperature conditionsSpecification:
Lamp Type : Four-foot T8 lamp
Power Output : 36 – 40 W
Input Voltage : 220 – 240 V/AC
Frequency : 50 Hz
SKU: Ballast1 -
TRUNCKING
40 x 25mm PVC Trunking
* N450.00 (per length)
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 1497 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 2.3-4amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload2
There are no reviews yet.