Steel Cable Trunking
Manufactured from galvanized steel our range of galvanised steel cable trunking is available with a wide range of accessories.
Based on 0 reviews
Be the first to review “Steel/Galvanized Cable Trunking – 75mm x 75mm (3m Length)”
-
ACCESSORIES, ELECTRICAL FITTINGS, Electro
Galvanized Steel Electrical Conduit Tube Pipe – 25mm
Galvanized Steel Electrical CONDUIT Protect insulated electrical conductors and cables
Galvanized steel construction provides shielding from magnetic fields and protection from impact damage and crushing
Electroplated couplings prevent zinc build-up
Designed for use with threaded connections
Length : approximately 3.8mtrs.SKU: steel2 -
Electro, ENERGY SAVING BULBS, LIGHT BULBS, LIGHTING
Torch B22 (Pin) 11W Energy Saving Bulb
Specifications:
• Optional wattage: 7-105W
• Operating voltage: 110 to 130V or 220 to 240V
• Frequency: 50/60Hz
• Average lifetime: 6000hrs/8000 hrs/10000hrs available
• Optional base: E27/B22/E14
• Optional Color Temperature: 2,700K/4,100K/6,500KApplications:
Shopping malls, table lamps, pendent lamps, supermarkets, restaurants, shops, hotels etc.SKU: 861 -
ELECTRICAL INDUSTRIAL, TRANSFORMER
ABB Transformer 800kVA/33 ABB Cu/Cu Oil Filled Groundmount Transformer
ELECTRICAL INDUSTRIAL, TRANSFORMERABB Transformer 800kVA/33 ABB Cu/Cu Oil Filled Groundmount Transformer
Distribution transformers are typically oil-immersed and suitable for pole-, pad- or ground-mounting. They represent an economical option for certain networks, particularly those with low population densities.
Depending upon requirements, transformers may be connected between two phases of a three-phase system (two high voltage bushings) or from one phase to ground (single high voltage bushing).
The units are suitable for residential overhead distribution loads, as well as light commercial or industrial loads and diversified power applications.
Product scope
- Primary voltage: up to 36 kV
- Typical fluid: mineral oil
SKU: dts80033 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 1.6 – 2.5amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload3
There are no reviews yet.