T2 lamp holder with push bar, threaded. 0.5in threaded, T2 lamp holder with push bar switch. If in doubt consult a qualified electrician
Lamp Holder 1/2in Push Bar
Always read instructions.
₦150.00
CompareBased on 0 reviews
Be the first to review “Lamp Holder 1/2in Push Bar”
-
ELECTRICAL FITTINGS, Electro, TRUNCKING
25x40mm Dignity PVC Trunking
The advantages of PVC Wire Duct:
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Cables can be secured to clamps or ties.
8.Various hardware accessories available to fix, support and install.
9. Safe smooth edge design to protect cable.
10.Easy for line check and cleaning , easy maintained.SKU: 409 -
DISTRIBUTION BOARDS, DISTRIBUTION BOARDS, Electro
Powertec 6 Way 100A Single Phase Consumer Units DB C/W MCB
DISTRIBUTION BOARDS, DISTRIBUTION BOARDS, ElectroPowertec 6 Way 100A Single Phase Consumer Units DB C/W MCB
Features
These are most elegantly designed DBs, to suit the decor of homes
Raised neutral link for easy wiring
Spring loaded outer cover swings open by just pressing the lock as in case of Elegance series.
Supplied with masking sheet to protect components from cement during plastering
Supplied with neutral & earth link, top & bottom detachable platesSKU: 280 -
GEAR SWITCHES
HAVELLS 800A ROTARY CHANGEOVER SWITCH
• Suitable for individual mounting, inner mounting holes and mounting brackets provided in enclosures.
• Sheet steel enclosure duly phosphatised and powder painted for longer life.
• Provision for door interlocking.
• Termination suitable for Aluminum cables, adequate knockouts provided in the enclosure for cable entry
630A, 63A, 400A, 200A,SKU: 1572 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 23 – 32amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload6
There are no reviews yet.