Electrical data
Nominal voltage 220…240 V
Mains frequency 50/60 Hz
Input voltage DC –
Operating frequency 25 kHz 1)
Length 103.0 mm
Width 67.0 mm
Height 31.0 mm
Mounting hole spacing, length 110.0 mm
Product weight 150.00 g
₦22,800.00
CompareElectrical data
Nominal voltage 220…240 V
Mains frequency 50/60 Hz
Input voltage DC –
Operating frequency 25 kHz 1)
Length 103.0 mm
Width 67.0 mm
Height 31.0 mm
Mounting hole spacing, length 110.0 mm
Product weight 150.00 g
For certain products, a driver is necessary to enable the connection between your product and a computer. On this tab, you will find the applicable drivers for your product or in the absence of any drivers, an explanation of your product’s compatibility with each operating system.
‘-For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or from your local authority-
Stanley Products always provides new technology for all industrial requirements, with excellent value for their investments. You can depend upon for matchless quality on all Stanley Products. Our new range products in sheet metal Side Handle Operating Switchgear are made as per industrial requirements with powder coating. This certificate of “Stanley” original products, issued with the assurance as the same has been manufactured in accordance with requirement of IEC-60947-3 (2005-06). Quality system, standards and mechanism has been tested satisfactory to the specific test as follows: 1. Dielectric Test 2. Mechanical Operation Test 3. High Voltage Test 4. Insulation Resistance Test 5. Temperature Rise Test 6. Mini Volt Drop Test STANLEY 63A Gear Switch
Distribution transformers are typically oil-immersed and suitable for pole-, pad- or ground-mounting. They represent an economical option for certain networks, particularly those with low population densities.
Depending upon requirements, transformers may be connected between two phases of a three-phase system (two high voltage bushings) or from one phase to ground (single high voltage bushing).
The units are suitable for residential overhead distribution loads, as well as light commercial or industrial loads and diversified power applications.
Product scope
There are no reviews yet.