Product Features
120kA/500V 50kA/660V 63A 63 Amp Ceramic Fuse and Base New brand with high quality
Product Description Mainly used for protecting the electrical circuit against overload and short-circuits.
Stanley 63Amp Fuse And Base
Protection against overload and short circuit in electric lines.
₦33,000.00
CompareBased on 0 reviews
Be the first to review “Stanley 63Amp Fuse And Base”
-
-
CHANGEOVER SWITCHES, Electro, GEAR SWITCHES & CHANGEOVER
Standard 400Amps Changeover Switch
Features:
DMC terminal blocks are provided for cable termination having excellent mechanical, thermal and dielectric properties.
Side Handle Operation.
The enclosure is made of sheet steel suitable for individual mounting.
Terminals suitable for both Al. & Cu conductors.
Adequate knockouts provided for entry of cables.
Door interlocking facility provided.
mounting holes for switch ratings upto 320A and mounting brackets
for switch rating of 400A and above.SKU: Standard400 -
ELECTRICAL INDUSTRIAL, TRANSFORMER
ABB Transformer 800kVA/33 ABB Cu/Cu Oil Filled Groundmount Transformer
ELECTRICAL INDUSTRIAL, TRANSFORMERABB Transformer 800kVA/33 ABB Cu/Cu Oil Filled Groundmount Transformer
Distribution transformers are typically oil-immersed and suitable for pole-, pad- or ground-mounting. They represent an economical option for certain networks, particularly those with low population densities.
Depending upon requirements, transformers may be connected between two phases of a three-phase system (two high voltage bushings) or from one phase to ground (single high voltage bushing).
The units are suitable for residential overhead distribution loads, as well as light commercial or industrial loads and diversified power applications.
Product scope
- Primary voltage: up to 36 kV
- Typical fluid: mineral oil
SKU: dts80033 -
CIRCUIT BREAKERS
TeSys Schneider Electric Overload Relays 23 – 32amps
3-pole relays with screw clamp terminals
These overload relays are designed for the protection of motors. They are
compensated and phase failure sensitive. Resetting can either be manual or
automatic.
Direct mounting: under the contactor for versions with screw clamp terminals only;
pre-wired terminals, see pages B11/28 and B11/30.
Separate mounting: using terminal block LA7 K0064 (see below).
On the front face of the overload relay:
b selection of reset mode: Manual (marked H) or Automatic (marked A),
b red pushbutton: Trip Test function,
b blue pushbutton: Stop and manual Reset,
b yellow trip flag indicator: overload relay tripped.
Protection by magnetic circuit breaker GV2 LE, see pages A6/11 and A6/20.SKU: Overload6
There are no reviews yet.